The anti-corrosion roof panels are fixed using aluminum profile fasteners. Corrugated anti-corrosion roof panels are fixed using anti-corrosion roof panel brackets and self-tapping screws, then sealed with sealant. The anti-corrosion roof panels are generally located in the middle of the span.
A cover plate must be used when connecting the anti-corrosion roof panels to the self-tapping screws. Polycarbonate sheets have significant thermal deformation and are easily sheared by self-tapping screws; therefore, larger holes should be drilled at the self-tapping screw locations. The expansion and contraction of the skylight panels must be considered when installing them.
Anti-corrosion roof panels do not require overlapping within 12m; overlapping is required beyond 12m. The overlap length is 200-400mm. Two coats of sealant are applied to the overlap. Lateral overlaps do not require edge trimming. Longitudinal overlaps of anti-corrosion roof panels generally do not require edge trimming; they are directly fixed with self-tapping screws and then sealed with sealant. Interlocking panels require edge trimming. Longitudinal overlaps of anti-corrosion roof panels should be located near the purlins.
